Plylox Corner Clips

CORNER-CLIPS
Stainless steel 1/4" Plylox corner clips for clear boarding. Hurricane rated, the fastest and easiest way to board windows without drilling holes, nailing or ruining siding.
Site PriceQty
Qty: 10$17.99
Qty: 20$32.99

Installation Instructions

1. Measure every window casing.

Make sure to:

  • Record all measurements.
  • Work from left-to-right.
  • The recorded height should be the same as the measured height from top to bottom of the window casing if you take away 1/4". The recorded width should be the same as the measured width from both sides of the window casing minus 1/4". This way you'll have 1/8" clearance around all of it.
Design Wind Speed
(MPH, gust)

Maximum Allowable PLYLOX™ Clip Spacing (inches)

Nominal Recessed Width of Window (Inches)

24 36 48 60 72 96

Clip Spacing in Inches on Vertical Edges

110

24 24 24 24 16 8
120 24 24 24 16 8 6
130 24 24 16 8 8 N/A
140 24 24 12 8 6 N/A
150 24 16 8 6 N/A N/A

2. Cut 1/2" plywood or polycarbonate clear boarding to the size that was recorded for every window.

  • Mark every cut piece with it's corresponding label, Example: FF1, the window at the left front of the house on the first floor.
  • If you decide to keep the chart and label the plywood or polycarbonate clear boarding covers, you will not need to label the casings.

3. Put the clips on every plywood or polycarbonate clear boarding cover (if the window is 24"x24" or smaller, only use two clips).

  • Each clip should be placed on the edge of the plywood or polycarbonate clear boarding cover no more than 24 inches apart.
  • Be sure that the tension legs are facing you.

4. Push the plywood or polycarbonate clear boarding covers with the tension legs to the outside into the casing.

5. PLYLOX also works in round windows like they do in rectangular windows. You can adjust the number of clips used to make up for different shapes and sizes of different windows.

    Customer Reviews


    Write A Review